A simple Spice Rack Carousel for the kitchen. Print One Carousel Base and One Carousel Tray Top. Then print as many Carousel Tray Middles as needed. I'm sure there is a height limit that you can get to before it tries to tip over but it should work for at least two Middle Trays. There is 11 Holes per tray so you could potentially hold 11 if only printing the base and Top to 33 Spice containers if you print two middle trays and one top. It also may help to put some rubber grip or some grip tape on the Carousel Base to keep in from sliding. The trays and the Top should then rotate freely on each other I have not tested this yet so the Holes for the spices to sit into may be really loose or tight. I designed the holes to be 2" in diameter. I believe the spice containers you get from the grocery store are 1 1/2"-1 3/4" in diameter so they should fit inside the holes. This is mainly designed for the Short Spice containers but could fit the taller ones on the top tray. The 11 Count isn't small enough for the Makerbot Replicator to build. The 4 Count and 6 Count trays are though. Thy reuse the Base and also can be mix and matched together.