Anemometer for wall mounting.Inspired by the other anemometers on thingiverse. Easy to make - requires 1 x 8mm bearing - the pictured version was printed using the Replicator 2. Print the following: Anemometer Cup x 3 - using standard settings; Anemometer Support x 1 - standard settings; 8mm Hub x 1 - standard settings; 55mm8mm Rod x 1 - 100% infill on standard; WingNut 8mm x 1 - 100% infill on standard; 8mm Nut x 3 100% infill on standard; The wind cups fit into the hub, the hub fits the 8mm rod with a wingnut at the top. The 8mm nuts secure the hub and the bearing, as pictured. It then simply fits into the main support and its ready to go.