Similar to the last one, but I also need to mount servos facing forward to a shelf.This thing allows you to mount a server with its plane of rotation in parallel with a shelf that it is sitting on securely.The extent of the shelf clip is long enough that you could use glue to attach it to the shelf, and it will probably provide enough support for the applied torque.If this is not good enough, you could drill a couple of holes and use some screws.Similar to the side facing one: 1) Print one of these out 2) Take your servo's top of bottom off so that it can be fit into the sleeve 3) Press the servo into the sleeve (a very tight fit) 4) Put the top/bottom back on your servo 5) If the friction fit is not good enough for your needs, use some nuts/screws to attach the mounting holes on your servo to the mounting tabs on the sleeve. 6) Put it on your shelf 7) Rejoice!