A stand to hold the RSA SecurID at a better angle, so the number is easier to read. I saw kazsoft's stand and realized how useful it would be, but I wanted something lower and harder to knock over. I made mine just high enough to be seen over the back of my keyboard. When nudged it slide rather than tips. The "waist" in the design allows you to pick it up off the stand easily. The model has a brim to help it stick to the print bed, and the bottom edge is turned under at 45 deg to give it a clean-looking bottom edge after you trim off the brim.2 shells .2mm layer height 10% infill No rafts No support