While the original printed without to much sag from overhang it became more noticeable at larger scales so I thought why not slice it into 3 parts and acetone it together later?Note: Files are scaled rather large. If you want to print a smaller cube remember to scale all three parts by the same amount!Note: If you normally print with a high number of solid exterior layers you will want to remember to turn it down our you may end up with an almost solid cube. I normally print with 5 exterior layers for structural parts and forgot to turn the number down....Note: You can choose to print A and B as either solid or 'Hollow' (8cm plug removed from the center)A: x1 B: x1 C: x2 (Top/bottom)