A 3d printable sight for a recurve bow. Designed to be assembled with screws from local hardware store and 3D printed parts. This is still a work in progress. Version 2 is being printed this week and will be tested on Wed (9/10/2014). Will update when I see how it turns out. V2 uses the pin sight from v1.This is a work in progress. I tested this version over the weekend. These are the results that I have found so far. I may have gone a bit overkill with Version 2. It is definitely going to be stiffer. It may be more than needed. Will shoot it tomorrow night (9/10/2014) and see how it goes. This version is adjustable without dismantling. The slider doesn't quite fit. I would wait for Version 3.