Please read this: https://sites.google.com/site/motorpixiegimbals/news/nofurtherdevelopmenton3dmotorpixiegimbalinthenearfuture before trying to create this thing. In short, you'll need the way too expensive 32-bit BaseCam controller to make it work in a satisfactory way) 3D gimbal for DJI Phantom 2 Vision Weighs 280 grams RTF. (But "removes" 17 grams from P2V, original dampener plate and dampeners) Total weight gain: 263 grams (Comparable to the RotorPixel 2D gimbal). Warning: Tuning the BaseCam software will drive you mad... The source files are included also, so anyone can improve on the design to their liking. Please share pictures of your build, I would love to know my design is being used :-)To complete this build, you will also need: Leg extensions: http://www.thingiverse.com/thing:337486 1x BaseCam 2 axis controller board with IMU 1x BaseCam YAW axis extension board 2x Turnigy 2206-140Kv gimbal motors 1x Turnigy 2804-210Kv gimbal motor 12x M3x8 hex screws 12x M2x6 hex screws 12x M2 (4.8x0.3mm) washers (ADDED 22/6/2014) 6x M3x20 nylon screws 1x M3x16 screw 1x M3 nut 1x 3.5mm female 4 pole jack 1x 3.5mm male 4 pole jack with wires (90 degree angle) 1x 50mm 1 pin wire (pitch control) 6x dampeners Mad soldering skills FC200 specific: 1x M3x16 screw 1x M3 nut GoPro Hero 3(+) specific: 2x M3x16 screw 2x M3 nut Plastic tubing to protect exposed FC200 jack