Enhance your hexagonal castle with this Wizard's Spire, and rain fire down on your enemies. This thing adds models for the wizard's spire and fire tokens to the tower, wall, and buttress models from Castle Game Pieces. Flames fit over the tower and wall parapets, or can sit flat on the table. The wizard's spire was designed to print at .2mm layer heights to best show off the brick pattern. You will need 9-12 flame tokens to fully defend your castle. I found it difficult to print a single flame do to their small size, but the Fire_plate9.stl allowed sufficient time for each layer to fully cool with fan-cooled PLA. The flames are derived from macouno's lovely model, "Blu On Fire." An OpenSCAD script is included which crops the original STL and adds the bottom hole. The tolerance parameter can be adjusted if the flames are too tight or loose to sit easily over a parapet.