Case for 2.5" HDD. Printable in one pice.Get one of those SATA to USB converters: http://de.eachbuyer.com/usb-2-0-to-sata-7-15-pin-adapter-cable-for-2-5-hdd-hard-disk-drive-p15696.html (5€ free shipping worldwide) Ptint until the cabe hole is hald done and inset your converter. (Pay attention, that the extruder does not chrash it. (Use avoid crossing preineters in Slic3r!) Ptint until close under the first layer of the top cover. Put in your HDD and plug it into the converter. Put some toiletpaper between the HDD and the walls to avoid rattling. and wait for the printer to finish. DONEIf you likle this please allso see my version two!http://www.thingiverse.com/thing:1375058I can customize this to fit your specific HDD!Just leave a comment and we can talk!