This is a remix of TJWeb's 3 part micro hexacopter. Thank you TJWeb for the base model! I added zip tie slots to hold the 3 parts together. I did this to keep the parts from sliding up or down during flight. Glue does the job but makes it impossible to replace a part after a hard crash.You will need to print three of the four parts. Hex-Right.stl, Hex-Left.stl and then either Hex-Rear.stl or Hex-Rear-36mm.stl. The 36mm flavor includes standoffs at the 30.5mm spacing for a 36mmx36mm flight controller such as the Naze32 and many others. I am printing mine right now using ProtoPasta CF reinforced PLA. I will add pictures when it is complete.