I made this up to perfectly fit my FliteTest AirBoat for an FPV camera with the pan ability. Ignore the burn marks on the 620TVL camera mount - these were put there on purpose as I was going to cable tie it to the servo horn, but instead I used generous amounts of hot glue, it seems to bond to PLA really well :).Printed in PLA at .25 layer height, .2 infill. It does not require supports, print it with the servo plate on the bottom, and the 2 pieces will print fine at the 45 degree angle they are at. If you are printing with PLA you WILL need cooling to allow for the overhang.