It is spring. And that means your friendly Apis Mellifera (honeybees) may be running low on their stored honey reserves, but what to do before the flowers start blossoming? Answer: Feed them some sugar water with one of these! Features: IMPORTANT: This currently has a design flaw in that I forgot to account for the height of the canning jar for attachment. What that means is until I update the size you'll have to use a jar shorter than a pint. If that's ok with you, go ahead and print. If not, you may want to watch this 'thing' for the pint-compatible version to be released.I printed from PLA with 10% infill and 3 shells (to give strength to threads). I tried to design this so that you wouldn't need supports. I didn't use any, but there were a lot of "hangies". I guess it all depends whether you'd rather cut off those or cut off the support material. Either way you'll need a chisel or sharp screwdriver to clean the inside. Also, my printer filled in the holes so you may need to poke them back out with a hot dental pick or needle.