Case for BlackBerry Passport Molded hand grips. 2mm of side padding and holes for all ports and microphones. I wanted a slimmer fitting case than the leather flip cover the phone originally came with. This case is intended to offer some protection against dropping the phone, but don't drop it. Seriously...don't. Change History: v1.0: Initial Release v1.1: Hole for USB charging port enlarged for better connector fitI made mine out of soft PLA and used supports to get all ports to print nicely. I used a slower print speed (15mm/s) to get a nice finish with soft PLA. I recommend using some sort of pliable print material to facilitate attaching to your device. It takes about 5 hrs and 38 minutes to print at that speed. Just set it and go to bed. Your new case will be ready for you in the morning.