Assemble these triangular castle pieces into an indestructible fortress! Hexagonal walls keep out all but the most tenacious monsters. For those, you may need to print the additional Wizard's Spire Game Pieces Print: The models are designed to print at .2mm layer height with a .5mm nozzle, but should look even better with higher resolution. The STLs are all manifold, so they should slice fine as is. However, for best results you will want to double-check the gcode afterwards. The fortify tokens look best if the top infill goes the full length of the piece. I had to rotate the model 45 deg in Slic3r to get the fill orientation correct. Make sure the thin vertical stripes on the fortifies are sliced as continuous lines rather than a zigzag (or missing completely). If you tweak the layer height, walls and tower perimeters should contract and expand smoothly at the gaps between layers of bricks, and the top surface should follow the cobblestone pattern.