I have a coworker who has acquired the nickname "Chainsaw Wielding Garden Gnome." She proudly displays garden gnomes in her office. A few of us thought it would be fun if I printed a gnome with a chainsaw. Two Thingiverse searches later, I had a gnome and a chainsaw. I put them together in Blender. I had to scuplt the gnome a bit to remove the bulge on his right shoulder. I also removed some detail from the chainsaw to make it easier to print upright. I didn't worry about the rest of the overhangs on the chainsaw, but would if this was going to be printed more often. Now you can have a chainsaw wielding gnome as well. Use it to protect your garden from rabbits or a zombie gnome invasion. The black specks in the picture of the print are from a little clean up I did with a file. Blend file included for your tweaking fun.I printed at 0.2mm resolution and 10% infill on a MakerBot Replicator. I used a raft because my kapton tape was pretty messed up. I did not use support, but some of the overhangs should have it.