This full scale, fully functional replica of Corvo's blade from Dishonored is based directly off of the in-game model. The only major difference is that the blade had to be shortened to fit inside the handle since the blade shown in the game is impossibly long! Check the instructions tab for information on how to assemble the model. WARNING: This model is intended for use as a prop and not as a weapon. The blade is not sharp enough to cut but the end is pointy enough to inflict damage through puncturing.We used a 0.2 mm layer height and 10% infill for all of the parts. We recommend using a raft and supports for the Blades, Handle, and Claw parts. The Latch part prints best without a raft or supports. Check out this picture http://oi58.tinypic.com/2mesl5w.jpg showing the steps to assemble this model or read the instructions below. You will need: