I have for some time wanted to get a new desk lamp, but i have not been able to fine one that i liked and that used led's so i decided to make my own, so here it is. There is a picture with some red parts that show some different versions of parts and print settings. Se instructions for print-settings and material's used.Print one of all the parts. My print settings: 0.1 mm layerhight, PLA filament, 210 nozzle temp, 60 bed temp, 30 mm/s print speed, simplify3d slicer, 1 mm support pillersize(silplify3d setting), 30 deg support angle, From bed support, 100% infill. I have also added a block to help drill into the tubes. Parts 14x m3 10mm countersunk screws (7 cut down to 4-5 mm) 3x 10mm 1m long alu tube 1x 30x15mm 1m long L-shape alu profile the alu parts did a buy at a local hardware shop.