UPDATE: New version uploaded. v1.1 - Enlarged the slots to correctly fit a 6/32" nut. This is a remix of MarkBenson's Drill Press for Hobby Drill. This base incorporates 2 slot for clamping down your project. Slots are for 6/32" screws that are 10mm long. The larger slots on the bottom are for the nut to fit tight so you don't have hold them while adjusting the Clamps. I also elongated the pass through for different setups. Instructions - See Instructions tab. P.S.: This "Thing" will not be here forever. I hate Makerbot/Thingiverse and will post this up on Youmagine and other 3D hosts. Once I have this model uploaded elsewhere, it will be deleted from here and a link added to the other hosts. UPDATE: Added Solidworks files.Print the base with 20% infill, 2 shells. I would also recommend using support due to the over hangs on the slots and the hole for the nut. Dimensions: 110mm x 125mm Print the clamp with at least 80% infill and 2+shells. The more infill and shells the stronger it will be.