Thanks to Dougwar for the original file titled Earphone Tyde found at http://www.thingiverse.com/thing:416992 I scaled the file up to life size (21:1) and then modified the ear holes to fit my Sony Earbuds which tend to be a little bigger than some. I also pierced the ears with the proper size hole to fit the standard mini jack. I decided they should look a little realistic and since no two ears are alike I modified the ears shapes as well. I also created the stand to hold the ears because I figured I wouldn't be carrying these around and I use them at work so they sit on my desk when not in use.Printed on a Rostock Max V2 Sliced in CURA using .25 layer, 1.5 shell, 1.5 bottom/top thickness Filament: Laywoo-d3 light and Laywoo-d3 dark for the stand 60mm/s at 230c Prints better if you print each file separately. The stand should fit snug enough that you shouldn't need to glue it up. The ear piercing are just slightly bigger than the plug and depending on shrinkage you may need to file a little larger when done.