This is 3D scan of a female body modified to be printable.This model is derived from data downloaded from http://www.artec3d.com/gallery/3d-models/ I have included the original license.txt file and model data file here. The original model wasn't ready for printing. The mesh wasn't closed. I fixed that up in blender and tried to print. One of the legs fell over. I suspect there wasn't enough surface area on the bottom of the foot to hold it up with the print head pushing it around. I added a torus as a base in blender and tried again. It came out fine. Pics shown above of the first print. No raft or supports were needed. Here is the first few lines from the license.txt file: This 3D model by Artec Group inc. (www.artec3d.com) is licensed under the Creative Commons Attribution 3.0 Unported License. To view this license, visit http://creativecommons.org/licenses/by/3.0/ or send a letter to Creative Commons, 444 Castro Street, Suite 900, Mountain View, California, 94041, USA. Permissions beyond the scope of this license may be available at http://www.artec3d.com/contact/.