My wife saw something like this in a magazine and asked if I could put my new hobby to use for making something functional! It allows you to hang up to 5 hangers on the wall. Arm will swivel up to get it out of the way when not in use. The nut and bolt were generated using the NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory. The arm will swivel up, but may have problems staying up. I'll work on making it "lock" into place a little better when not in use.Print one of each piece. The arm is 180mm long, so it could be a squeeze on some platforms. In that case, you may want to try positioning it at a 45-degree angle (give or take 15 degrees). It could also be scaled down to fit but may make inserting the laundry hangers into the holes a little more difficult. I would also recommend printing the bracket vertically (as it is displayed in the picture). I'm afraid the pull of a heavy arm might cause some layer separation and break the bracket. And nobody wants clean laundry on the floor.