Yo,Do you have a Samsung Galaxy Tab 8.9" or 10.1" tablet?? If so here is a full featured docking solution!At work we bought a fleet of 8.9 LTE Tab's and I immediately began creation of a dock that would work with a naked unit or with a TPU case on it.Each dock has an adapter locking center channel and cable tunnel for the 30 pin power/data cable. I included 2 40mm unique dowels so you can easily slide the unit apart for addition and removal of the cable. The unit holds your Tab at a 20 degree angle perfect for desk usage or next to the bed. I widened the stance with the rear wedges so you can rest assured there will be no tipping even if your a hardcore screen basher. There are also dual front and rear speaker ports so you can mega jam even when docked with the 8.9!I have uploaded 2 different solutions that work on each tablet variant (not physically tested on the 10.1 but the qualifying dimensions are the same):1.) A standard sized dock that minimizes plastic used and print duration. This dock allows you to grip the side of the Tab in the dock and easily use a thumb keyboard without pulling it from the dock! 2.) A jumbo dock that goes almost to the edge of the 8.9 and looks like a dock that you might buy at a retailer (or at least I like to think so...).All docks pictured with logos were on my beta units only and all uploaded docks are free of any branding. I have also attached my Sketchup master for your modding pleasures.Make up your mind using the description above:Go standard: -Print "GalTabDockLeft.stl" and "GalTabDockRight.stl" -Clean with a knife -Insert connection dowels -Insert data/power cable in to indention -Push halves together -Slide Tab in -Enjoy home made dock-it-ization!Go Jumbo: -Print "GalTabDockBigLeft.stl" and "GalTabDockBigRight.stl" -Clean with a knife -Insert connection dowels -Insert data/power cable in to indention -Push halves together -Slide Tab in -Show your friends your a regal tablet balla!Printed on:TOM # 4890 MK6+ 1.75mm .4 nozzle ABP with aluminum plate topper and titanium belt covered in kaptonPeep what I'm currently printing on my bot at: mega.dlinkddns.com:4445/snapshot.cgi?user=megaweb&pwd=1l1k32v13w and click refresh in your browser to request another snap shot.