A work in progress attempt at making the candelabra arm hollow, for adding power wires for LED lighting.I've tried printing this, and it seems to be hollow as designed, but I can't get the only wire I've got to go all the way around all the curves. Maybe someone else will have better wire, a better print, or a cunning plan, for making it work.The hollow ends with a gap in the middle of the tab to attach to the main candelabra body - ideally, the wires should be able to rejoin the main body through that.- UPDATE [5th September] - Two newly updated versions - both with the split tab raised up to the half-way mark. Version 07 has a ridge along the end of the tab as a support leg. Version 08 changes the ridges to 'T' shaped, to avoid a printing island.Print one as a test, first, to see if you can get your wires through - it's a relatively quick print (20 minutes or so on a Thingomatic).I've got plans to attempt to stop the print before the hollow is sealed - and embed the wire in the channel to then be printed over - if you try this, please let me know in the comments!