My teenage daughter is working on a "steam punk" costume, so I volunteered to make some goggles for her. The first printout was sloppy in areas due to overhang, but it was easy to clean up with a little clipping and cutting. It was a good proof of concept anyway. This is an updated version that should address the overhang issues.This part was made with Tinkercad. Edit the part online at: https://tinkercad.com/p/acc02f92ab75127bThey will need some cleaning up, but they came out as intended. To finish off the initial look, I brought out the gilding pen and fancied them up a bit.