These are wall objects for use with intersecting hexagons. The ones presented are not full height walls and are intended to act as markers while facilitating manipulation of miniatures. Further plain wall files will be added to this entry as they are designed. The wall files are coded as follows: c: goes across the centerline of a hex s: goes across one hex face (edge of hex) x: spans a hex at 90 degrees from centerline walls A "double" wall extends past the hex such that one unit is used every other hex. The 'c' and 'x' walls can be used to construct a square room.Only OBJ files provided as I've had no luck with STL for these objects. They are modeled in Carrara and filtered through Hexagon as Carrara's wavefront export is incomplete. Hexagon's STL export hasn't worked well on these meshes and repairs with netfabb have done strange things to the object. Printed at medium resolution in PLA but with 3 shells and 20% fill. Set scale to 222.68% if fitting to hexagons printed at 32mm (y dimension). The first printing at defaults for medium resulted in the posts being overly weak (two snapped off pretty quickly). Use care in detaching as the posts may still snap.