The original hanger was used to hold a towel, and eventually broke from stress of pulling the towel off too hard. I tried fixing it with hot glue, but that only worked temporarily. So I decided to make a 3d model with Google Sketch-up and print it out. The print worked, but I added too much material in some places. I think I fixed this issue, but you might need to cut away a couple of layers with an utility knife like I did. I've made this model shorter then the original because of the limited area my printer can print in.I printed this with an printrbot simple 1405. I added supports to the print with slic3r. Support settings for hook 2: overhang threshold: 50 degrees Pattern: honeycomb pattern spacing: 2.5 interface layers: 3 (everything else:0) layers and perimeters 0.3 mm layer height 100% infill rectilinear infill pattern