This are my Ideas of housings for the well-known Smart-LCD Controller. It fits on a standard Kossel with a 3 x 15 mm frame-base. The Versions V2.x are a little bit higher than the top-most beam on an Kossel-Mini. This is intended to be so. Design, you know? :-) NOTE: I've noticed that there are significant tollerances concerning the placement of the buzzer on the SmartLCD board. On the two boards I'm currently working with, the buzzers are 4mm - 5mm off alignment. Therefore I made the hole for the buzzer a bit larger than the buzzer's actual diameter. Oh - and don't forget the knob. ;-) If you want to print V1.1 or V1.2 with the panel faced up, you have to rotate the object by 26.39° around the X-Axis. To print with the panel faced down, the rotation is 180° around the Y-Axis.