THIS IS STILL A WORK IN PROGRESS More info will be added later Basics: -H-Bot setup -Uses fishing line/thread -Open Source -Easily scalable -Easy to build -Cheap Vitamins: -M4x10 Button screws (x49) -M4 Nuts or T-Nuts (x49) -210mm Aluminum Extrusion (x4) -240mm Aluminum Extrusion (x4) -209.5mm Aluminum Extrusion (x1) -330mm Aluminum Extrusion (x4) -140mm Aluminum Extrusion (x1) -Nema17 Motor (x4) -240mm Threaded rod of choice + flange nut (x1) -608 Roller bearing (x6) -Fishing line or other strong thread -M3x8 Socket Head Cap Screw (x16) -M3x18 Sock Head Cap Screw (x5) -M3 Nut (x5) -Spring (x3) -625 Roller Bearing (x1) -1.75 PTFE Tube [At least 50cm length] (x1) -Controller board of your choice -Power supply of your choice -Hot end of your choice (PEEK recommended (Examples: Printrbot Ubis hotend, Geeetech PEEK hotend). E3D + more support to be added later)