As I always keep loosing the Takeaway menus I thought I would print a holder for them that I can put on the wall beside the phone. I actually had to abort the print before it was finished as to get the full 158mm height on my machine, I have to move the extruder drivers. This is why my made part looks a bit different. (if anyone makes one and takes a picture or I get time to print a new one, I will update.) There is also a business card holder on the front. The part also has screw holes in the back to hang it from a wall. (I have also added a sharp version without the radii on the top portion.) the walls are 1mm thick so I changed my printing width to .5mm this makes the part good with 1 outline without the need to use infill greatly reducing print time and removing nasty infill moves. The part is 158mm high in total to make sure you have the height on your machine, but as there is no need for top layers you can potentially stop the part early and still get a decent print like I did.