Created this to hold my lens in my car using the Mobius as a DashCAM. Going to mount it with double side tape on top and use the lens extender wire to hide the Mobius under the rain detector cover. Edit: Added an upgraded holder since the first "clamper" does not hold up good against the screw. The new one has a bigger hole and strengthen around the hole. The m3 5mm screw goes into the hole and screws directly onto the mobius holder. Have this mounted in my car now :)Printed with PLA at 220degrees, 30% infill 0,1mm layer height and 0,4mm walls. 50mm/sec.