After getting annoyed with spending too much time making a Moxon frame, and not enough time tuning it, I decided to create a frame in openscad. Since the UHF Moxon's dimensions put it outside what a 200mm printer can achieve, I made this one in two parts, which can be interdigitated and held together with fasteners. There's plenty of room for improvement, but I thought I'd get the design out the door so others can play with it. I deliberately left the mounting paddle fairly featureless because I figured it would be most likely modified by others.The moxon4.scad file creates one of three parts depending on the value you assign to the PartIndex variable. 1 creates the left panel, 2, creates the right panel, and 3 creates a mounting paddle.