For some reason this print seems aesthetically pleasing - so I'm told. Designed in MOI. Made in Bilby3D PLA on an Ultimaker 1 Note that the stl file was scaled up by a factor of 2. Without scaling up I've found it difficult to print successfully in PLA (on the Ultimaker) - I have printed without scaling up in ABS on a Robox. Even scaled up it's a bit of a challenge. See instructions for recommendations.I recommend: a) for 2x size 220C 0.2 layer height 1.2mm wall thickness 20% fill Brim Support touching baseplate. This is essential. Support throughout is an alternative though can be difficult to remove. Moderately slow print speed. b) for 1x size 220C 100% fill Brim Support touching baseplate. Really slow printing speed.