This is a dock for an Nokia Lumia 1020 that is using an Otterbox case. I am using this dock in my car attached to my ProClip mount. It is far to big for an 1020 with most cases. You could probably resize it to your needs. I created this dock from scratch in 123D Design.I printed this in low quality on a Makerbot Replicator 2x. It does not require support. You might need to adjust the scaling to your specific case or liking. I keep it pretty snug in the holder. The file does not contain the needed holes to mount it to the ProClip Mount. This is by design so I could make the holes as needed. For stability I changed the default infill to 100%. I am not sure if this really helped so your results might vary.