This is an endstop bracket for the Hall effect endstop sensor on an Ordbot hadron. Designed to go on the right upright makerslide and connect with an M3 bolt to a m3 tslot nut in the tslot on the side of the makerslide. Has not been printed or even tested for its ability to print. Adjust the clearence on the big block for other axis, or I will be posting Y and X laterThis is specifically designed for an Ordbot, will probably work with a Quadro or Hadron. It is also specifically designed to house the Halls effect endstop from Reprapdiscount (see ebay). I have netfabbed the model, but am still waiting on an extruder so cant print at this point.Still a work in progress, model has been posted to sketchups warehouse if you wish to adjust. Just checked the clearence for the wheels on the first model and felt it would foul, have increased the distance between bracket and holder to allow wheel to run past.Had one of these printed last night at a local Hackerspace (Melbourne) the print came out very nicely but was warned by the owner of the makerbot that it may not be dimensionally accurate. Have made some adjustments to the model and will upload shortly replacing the current models. Still not 100% sure the endstop will slide into the bracket the way it is intended too, but the new model should have more clearance.