A box to hold your Pokemon TCG cards and accessories. There's a compartment under the deck to hold counters, and a recess in the top to hold the "coin" that comes with the Kalos starter decks.1) Print both pieces. 2) Trim off the corder pads with a knife. They are only included to improve adhesion during printing. 3) Assemble. You may find that the detents make the box too difficult to open, in which case I suggest starting to open from the end, or trimming them a bit with a knife. Or of course feel free to modify the model to reduce or remove them. OpenSCAD sources are included if you want to make tweaks.