Power Morpher with an interchangeable hole for emblems. White Ranger Emblem included, depending on my son I may make other emblems. If you like this you will probably like my podcast too, where I talk about all things geeky. New episodes every week http://www.fandompodcast.com Edit: just realized I glued my medallion in upside down, don't do that :D Edit 2: So I sold some of these at Salt Lake comic con and I found that adjusting the z to 75% of the original printed faster and still worked great. I also recreated the coin that goes in the middle so that its flat purely for aesthetics. Pretty Basic print .3 Layer Height .08 infill 2 Perimeters Took about 2 hrs to print on Solidoodle with .3 mm layers. Emblem is 42.5 mm Diameter 7 mm Deep