My flatmate bought a surround sound system for the living room, unfortunately we had nowhere to balance the rear speakers other than on the sofa itself.So i thought this would be a good excuse to print out a solution for a stand. We could have bought some stands but where is the fun in that?Required Parts: The base prints out in four separate parts; three identical feet which slot onto a central hub piece. A couple of m3 bolts hold the feet onto the centre hub. 4 screws hold the timber into the base. Using the bolts supplied with the speaker, attach the speaker to the printed top piece. Then you can slide the top piece down onto to the timber till its at the required height, using the final screw to hold the printed piece to the timber.