Prusa i3 (Folger) top frame mounting brackets for the discount smart lcd controller.I have VERY limited knowledge on how to make .slt files, so there's probably many errors, but it worked on my end.:) IF YOU FIND ANY PROBLEMS, PLEASE P.M. ME SO I CAN TRY TO CORRECT PLEASE!!! Thanks. The mounting brackets slip over the top vertical frame, and into the top horizontal plates. The left one is shorter because my lcd display/controller came with only the short ribbon cables, and they just reach. (I have my ramps board mounted on the left side of my Folger i3.) I then made a cover from this file: http://www.thingiverse.com/thing:85644 Might need to rotate the parts so they are standing upright before slicing so you don't need support. Mine with 25% infill are plenty strong enough.