OK. So I crashed the first one pretty hard and destroyed two arms and the base of the frame from a 30' fall. Redesigned a few things and it's flying great again! I really love flying this one.I don't fly with the LEDs... but you can easily snake them through the arms and zip tie them along with the motor wiring. The stands purposely pivot around the M3 bolts, allowing you to mount the control board to the stands (using the shiny little bolts that originally held it in place) and orient them while fastening the base to the top casing. The gyro should be mounted using 8mm m2 screws passing through the rubber grommets. Make sure they fit nice and snug but not compressing the grommets. Vibration here is unwanted. all-together-now.stl can be printed comfortably within a 150 x 150mm print area!