Electronics enclosure with 40mm fan for RAMPS 1.4 with smart adapter that will bolt onto a Prusa i3 single sheet frame. This is a slightly improved version of http://www.thingiverse.com/thing:3917 which I liked very much! shout out to http://www.thingiverse.com/drandolph for the enhanced version of the original by http://www.thingiverse.com/oTTo. Thanks for sharing! I made a slot for the reset button to slide in and I also added another cutout for the smart adapter(I used the SAINSMART version which is just a bit wider than the other versions) looks good, works good RAMPS board slides in a whole lot easier. Apologies to those that downloaded the previous version that was loaded on 10/7/2013 that was a shorter version that wont fit the smart adapter..... oops new files are up, I also seperated the pieces in case you have already printed the lid and just want the updated box. ***Update, the lid is a tight fit with all of the wiring plugged in, I am going to create a deeper version of this to allow a bit more room for the fan inside. Will post when finished. I printed with 4 shells and 50% fill (I wanted it strong).