Here's a remote control holder that I designed to hold the 44 key remote control for an LED Strip controller (fairly common on eBay, and I believe the smaller 24 key remote would also fit in it). http://teslaandi.wordpress.com/2013/12/30/led-bedside-table-remote-control-holder/ With countersunk holes for screwing to the wall (you don't need to use all 4, I just put them there to give mounting options). Prints without support, but your bridging needs to be okay (not perfect, just okay). The opening is 58mm x 8.8mm (thicker than needed for the remote, to account for drooping in the bridges). Chamfered opening slot, for ease of use.