This is another reprap gen 6 electronics enclosure. It's pretty good looking, and has space for a power entry module, with switch. Keeps everything looking nice!If there's interest, let me know, and I'll try and put some kits together, but with a hinged lid. Laser cut all parts out of 5.7 mm materialStain if desired.Push sides onto bottom.Insert m3 nuts into t slots, followed by m3X16 machine screws, and tighten down. Put PSU into the bottom, and use 4 m4x12 screws and washer to mount the PSU.Mount power entry module, with 2 m3x12 screws and nuts. Mount the gen6 board with connectors facing the top, and usb connector pointing forward, using 4 15mm m3 standoffs. Using .25" quick disconnect flag terminals, and .2" fork terminals connect the power entry module to the psu. Using 2 more .3" fork terminals attach the 12v from the psu to the "Euro connector" on the main board. Button it all up and connect wiring to the gen6 board as labeled.