I made a SSD Cage for 2 SSD's with screwholes already built in. I used a caliper to measure all the dimensions, and the distance between the screwholes etc.. Mount the SSD's or 2.5" HDD's the opposite of each other. Size: 95mm long x 84mm wide x 32mm high. The V2 version has more ventilation for air flow, uses less filament and is smaller and lighter than the original version. V3 is just a bit more "fancy" and has more airflow, uses less filament and is smaller and lighter the the V2 version. The updates is updated with some of kb0nly ideas, so a big Thank you to him! :) Printing with 50% Rectilinear infill and 0.298925 layer height. Using brown PLA @ 205C @ bottom layer and 190 on the remaining layers. Mount the SSD's or 2.5" HDD's the opposite of each other. Size: 95mm long x 84mm wide x 32mm high.