This is my printable stl conversion of Printrbot's Open Source LCD Control box. Based on Printrbot's original DXF lasercut design that is posted here: https://www.youmagine.com/designs/printrbot-lcd-box It is designed to hold Printrbot's (or your own modded) LCD controller that can be used on any printer running the Printrboard controller. Assembly instructions can be found at Printrbot: http://help.printrbot.com/c/LCD_Panel This is based on the original DXF files, but has been modified to allow printing. The tabs/sockets, screw and nut channels have been modded to allow it to be printed and assembled with a tight fit. It works perfectly on my printrbot simple using .20 mm height, .4mm nozzle, 30% infill and only 2 perimeters. My prints fit really nice and tight with my setup. I suggest you print 2 parts that attach to each other and see if you have good results with your setup.The height is 5.6mm to allow the tabs/sockets to remain as close as possible to the original pattern. If your tabs/sockets are loose fitting, go to 3 perimeters or imports the files into tinkercad and extrude the height to 5.8 or higher. Feel free to mod, edit and share. But please give credit when due. and please share your results or any problems to further this project. Enjoy!