Replacement part for when the clip on swim goggles breaks. Modeled after Speedo's design, it works well with the 5mm wide silicone strap that is common to most goggles. This clip was designed in SolidWorks using basic sketch and extrude functions. Dimensions were directly measured from my Speedo Vanquisher goggles. This is a piece that, for me, often breaks before the goggles wear out or straps break. I used 100% infill on the print and designed the clip with additional load bearing geometry to maximize strength. In the photos, the clear clip is a manufacture original, while the red clip is my design.