The Tassimo base was too tall, and putting the cup in with no lift was too short. This one should be just right. Be warned.... My tassimo is at the office so I haven't tested it. It's strong enough, and the base pattern should fit. I have included the sketchup files and the stls in case anyone wants to adjust it. I printed with my normal settings on a rigidbot. 25% fill. Printed with PLA on Rigidbot 25%fill. THe bottom will probably need support, I didn't use any and it's a little stringy down there. But no one will see that, so I cleaned it up with a lighter.