Give these ancient kings a break from guarding the northern border of Gondor on the River Anduin and let them guard your filament! Simply print the left side and then the right side at full size, slide your spool over one and then push the two pieces together! Then enjoy your very own Argonath Spool Holder!I thought I would try and make something that was a little different than the other submissions for this challenge and that was more of a novelty holder than anything else. While it is technically printable and can hold your filament right now, it is only a rough idea and so there are a lot of improvements I plan to make later (multiple pieces so its easier to print and doesn't need support, clean it up and make it look nicer, etc.). But for now, I hope you all enjoy the one spool holder to rule them all!