A minimalist, thin wallet I designed for easy front pocket carry. Inspired by more expensive online offerings and a variety of projects on Thingiverse.The model is only 1mm thick and was successfully printed on a Replicator 2 with default Makerware "standard" settings (10% infill, 2 shells, 0.2mm layer height). The notches are sized for 1/4 inch rubber bands whose length can be chosen according to your preferences for tightness and number of items carried. I've had success with both 2" and 2 1/2" rubber bands that were readily available. Money was folded in thirds to get the portrait to show and is workable, however, at least for U.S. currency, folding in fourths has proven more practical. Money can also be held by the rubber bands on the outside if preferred. There is a thumb hole to easily slide out your money, ID, or cards. I keep my money on one side and my most used credit card on the other for easy access.