I got this model from 3DContentCentral. I had to modify it fairly heavily to print it, but the original design was by Alberto Garcia: http://www.3dcontentcentral.com/download-model.aspx?catalogid=171&id=12500 There isn't a need for the middle piece for the stand, I made a math error when I originally sliced it up and had to go back and make the mid-section. UPDATE: 8/24/15 - Added textured wings from the original model per Skipopotamus' request - need 4 of each inside and outside... lots of glue.I printed this on a Da Vinci 1.0 and fairly maxed out the bed (200mm x 200mm). I printed this a while ago, and started to make a second attempt at it, but never did finish. It requires a lot of glue and patience.