I added wings to the Animation-ish girl of MakiYoshida (http://www.thingiverse.com/thing:3130) because my daughter promised her best friend her dad will make her a fairy and i had no idea how to make a fairy in a weekend. I finally succeded.I printed it on a replicator sailfish 039 with a layer height of 0.1 mm, 2 shells, 15% fill, 100 feedrate, print temp 230, filament size 1.75 and full support. I added some support blocks to make it print better. Be careful with unwrapping it. Especially the out stretched pointy finger need some special attention. I finished the surface after carving away the excess plastic in a rice cooker set to warm with some acetone in the cooker. Make sure the fairy doesn't dip into the acetone. I used a metal stand to put it on. Do it outside or have a very good ventilation and avoid exposure to the acetone steam.